Tilt switch 20-39/H Tilt switch 20-39/H Tilt switch 20-39/H
  Tilt switch and controller& mdash; When the tilt switch probe used for material flow, blockage, and level detection is vertically suspended under external force and deviates from the vertical position by more than 15 degrees, the mercury contact inside the switch will act and the normally closed contact will open. After the external force is removed, the tilt switch returns to the vertical state, and the mercury contacts close again. Use the changes in the opening and closing of the internal contacts of the tilt switch to determine the working condition of the protective equipment, and take timely measures to achieve the purpose of safety protection. Features: The tilt switch can be used alone with the probe or in conjunction with the control device. The alarm output time is adjustable, and the control device has an adjustable delay circuit of 0-10 seconds, which can avoid false operation of the tilt switch caused by instantaneous tilt. The normal/alarm position can be set, and there is a jumper in the control device that can set the switch to a normal or tilted state. It is sturdy, corrosion-resistant, and easy to install. The control device is a printed circuit board structure. All probes are equipped with installation accessories 20-43 tilt switch controller (imported) 20-38 tilt switch controller (domestic). The control device has an adjustable time delay of 0-10 seconds, which can avoid false actions caused by instantaneous tilt of the tilt switch probe. In the control device, select vertical or inclined as the normal state through jumper selection. Two normally open and normally closed contacts are used for external alarms or control. 20-39-25 tilt switch technical specifications Power supply: 220 VAC± 10%, 47-62 Hz, 10W output: One DPDT contact, rated capacity of 5Amp/220 VAC or 5 Amp/28VDC, non inductive load time delay: 0-10 seconds, adjustable jumper: allows the switch to be set to normal state in vertical or inclined state 20-39-25 tilting switch application range: chute or adapter blockage detection conveyor belt deviation detection tipping machine discharge probe for belt or vibrating feeder shortage or no material detection 20-39-25 tilting switch technical specifications Contact: normally closed, mercury switch, 250mA/24 VDC, non inductive load optional: 0.8A at 240VAC/1.5A at 120VAC Rated temperature: -40 ℃~+300 ℃; WRNR2-15A  WRNT-31  WRET-31  WRNT2-31  WZP-235T  WZP2-235T  WRN-12B  WRE-12B  WZPT-31  WRN-13B  WRE-13B  WRN2-13B  WRE2-13B  WRN2-235T  WRN-14B  WRE-14B  WRN2-14B  WRE-15B  WRN2-15B